assface421
Aluminum
- Joined
- May 18, 2016
Fanuc 21i-MB controller problem. Femco BMC-110R2
The shop has just installed a (very) used Femco BMC-110R2 horizontal mill. There a few problems to sort out before it becomes operational. The first I am dealing with is the controller. There are areas that have the lettering on dials worn off. I tried to find a good picture of the lettering online, but all the the pictures are low quality. I need a good picture or diagram of the controller. I have enclosed pictures of the controller and areas of detail I need. Thank you.
The shop has just installed a (very) used Femco BMC-110R2 horizontal mill. There a few problems to sort out before it becomes operational. The first I am dealing with is the controller. There are areas that have the lettering on dials worn off. I tried to find a good picture of the lettering online, but all the the pictures are low quality. I need a good picture or diagram of the controller. I have enclosed pictures of the controller and areas of detail I need. Thank you.
Last edited: