Skip to main content

How your laptop will just keep getting faster

  • Story Highlights
  • Future transistors need to resist extreme heat or not generate as much
  • Advances in materials and design may also help speed up the everyday computer
  • Carbon is one material studied as a speedier alternative to silicon
  • One technology would allow your computer to boot up instantly
  • Next Article in Technology »
Decrease font Decrease font
Enlarge font Enlarge font

(PopSci.com) -- Since the invention of the transistor, silicon semiconductors have been king. But now silicon-based transistors are nearing the limit of their potential. Excess heat and manufacturing hurdles are impeding the development of ever-faster and smaller processors.

Researchers say aligning the spins of electrons in a semiconductor laser means operating more efficiently.

Graphene is a single layer of carbon atoms and is one possible alternative to silicon as a transistor.

Advances in materials and chip design to resist extreme heat and move huge amounts of data, quickly, will be crucial. Experts are exploring three technologies to overcome these challenges: spintronics, graphene and memristors. They are what will someday make ultra-energy-efficient supercomputers small enough to fit anywhere -- even in the palm of your hand.

Rebuilding RAM
Memristors will store large amounts of data and could make your computer boot instantly

Accessing data, whether stored in a spinning hard drive or in flash-based memory, is a time-suck and a power hog. The dynamic RAM that rapidly delivers data to the processor is almost maxed out.

"Both technologies for the magnetic hard disk and D-RAM are within a few generations of hitting brick walls," says R. Stanley Williams of HP Labs's Information and Quantum Systems Lab. He believes that circuits called memristors could be the solution. Memristors recently joined the resistor, capacitor and inductor as the fourth fundamental circuit element.

But unlike the others, a memristor has the unusual ability to remember the last resistance it held, even when the power is turned off. When the current starts up again, the resistance of the circuit will be the same as it was before, providing instant-on computers. After the memristor had spent some 30 years as a theory, Williams and his team designed the first one earlier this year. Five years from now, he says, the chips could sit in computers between D-RAM and hard disks to eliminate the boot-up process. Further down the road, memristors, which have higher storage densities than the best flash memory and faster write times than D-RAM, could supplant both technologies in one fell swoop.

Ditching silicon
Graphene sheets could trump silicon for small, fast devices

Don't Miss

  • In Depth: Edge of Discovery
  • PopSci.com: All aboard the AeroTrain
  • PopSci.com: Will the Japanese be the first to elevate to space?
  • PopSci.com: The flying car gets real

Heat is one major stumbling block to smaller, speedier processors; as heat increases, it becomes harder for electrons to move through most materials. But a novel twist on an age-old material might prove to be the key. Graphite is made of thin layers of interconnected carbon atoms. Four years ago, researchers at the University of Manchester in England tested the electronic properties of a single sheet of this carbon, known as graphene, sparking interest in what may be an entirely new branch of semiconductors.

This past April, they built the world's smallest transistor -- one atom thick and 10 atoms wide -- with the material. Unlike electrons in silicon, those in graphene can travel unimpeded for long distances. This efficiency, which is up to 100 times that of silicon, allows for ultrafast electronic devices that don't overheat (collisions cause heat). In addition to transistors, researchers hope to develop graphene wires that would transport electrons from one area of a chip to another much faster than current materials can.

Making electrons carry information
An electron's spin could encode more data for heavy-duty, low-power processing

Most electronic devices read data -- the 1s and 0s of binary code -- by measuring the presence or absence of an electrical charge. In the past decade, however, scientists have suggested that individual electrons could be turned into single 1s or 0s. Every electron has a magnetic pole and corresponding "spin." But instead of clockwise or counterclockwise, researchers distinguish electron spins by their orientation: up or down, 1 or 0.

Until recently, scientists had been able to control and detect electron spin (which allows the devices to operate at lower power) in semiconductors such as gallium arsenide, a material used in laser diodes, but not in silicon -- a major hurdle because the entire infrastructure of computer manufacturing is still ruled by techniques used with silicon.

Finally, last year Ian Appelbaum, now a physics professor at the University of Maryland, shot groups of electrons with aligned spins across 350 microns of silicon and determined the final angle of their spin. In another development, Igor Zutic and his colleagues at the State University of New York at Buffalo have shown that if you align the spins of electrons in a semiconductor laser, it operates at lower power. Such lasers could transfer up to 1,000 times as much data between different parts of a computer as the copper wires used today.

More about detecting electron spin from PopSci.com

Copyright © 2009 Popular Science

  • E-mail
  • Save
  • Print
Today's Featured Product:
2011 BMW Z4 sDrive35is
 8.0 out of 10
Recent Product Reviews:
RIM BlackBerry Torch 9800 (AT&T)
 8.0 out of 10
Motorola Rambler - black (Boost Mobile)
 7.0 out of 10
Samsung UN46C6500
 6.9 out of 10